Smarter Heating & Hot Water
← Back

How to Adjust the Flow Temperature on a Baxi 400, 600 or 800 Heat

400, 600 and 800 Heat all use the same fascia: a small radiator knob and two lights. There is no temperature display, so you cannot read 55°C on the boiler. Clip a pipe temperature sensor onto the heating flow pipe to see what you have set. There is no hot-water knob; the cylinder has its own thermostat.

The small disc with the radiator symbol is the rotary flow knob. Turn it right to raise the flow, left to lower it. Typical range is about 30°C to 80°C. The lights only show status, not degrees.

Baxi heat-only control panel. The rotary knob with the radiator symbol sets the flow temperature. There is no °C display.
  1. The rotary knob with the radiator symbol is the heating flow.
  2. Turn it towards minus to lower the flow, or towards plus to raise it.
  3. Clip a pipe temperature sensor onto the copper flow pipe leaving the boiler (the pipe that goes to the radiators). Wait until heating has been running a few minutes, then read it. Stop around 55°C if the house still warms. The cylinder thermostat still sets the hot water.

Look up your exact model on Boiler Manuals if the fascia does not match. Then return to the Baxi flow-temperature page or the Boiler Optimiser.